We usually encounter some faults in the process of using the mass flow meter more or less, so let's share some common troubleshooting methods today, let's take a look at it.

The failure of a general mass flow meter can be manifested in two aspects, one is a hardware failure and the other is a software failure. Then let's share with you the treatment of these two kinds of faults.

First, the hardware failure

If the error is too large, the totalizer display does not light or does not add value, the display blank position and other phenomena, the reason:

a. The installation is not standardized, which can directly lead to zero drift of the flowmeter. If the mass flowmeter is installed near the pump outlet, the sensor support strength is not enough, the connection flange is improperly welded to generate stress signals, and the cable is subject to electromagnetic interference.

b. Wiring problem

If the display does not light, check the power supply connection of the totalizer. If the fuse is burnt, confirm the input voltage and the standard voltage, and the AC and DC forms are consistent. If the totalizer does not increase with the flow rate, the totalizer wiring should be checked. If the accumulator is equipped with a forward/reverse procedure, check the flowmeter wiring. If the flowmeter is not wired correctly, the totalizer will be reversed. Does not increment when streaming.

c. Process media changes

If there is air entrainment, gasification or two-phase flow in the measuring medium, the transmitter will display an alarm. In severe cases, the sensor will stop working.

d. The transmitter fails.

e. Sensor failure.

f. Pipe cleaning problems.

Second, the software problem

Mass flowmeter troubleshooting--Be sure to pay attention to the zero calibration under the current working conditions before the flowmeter is installed. It must be ensured that the flowmeter is filled with medium and then the two-end shut-off valve can be closed to zero calibration. There are many methods, panel operations, handheld devices, and the use of prolink II software.

a. Zero calibration is incorrect.

b. The parameter settings are incorrect.

c. Pulse fluctuations of the power supply.

The di/o configuration is incorrect (must pay attention to the range).

e. Incorrect operation

Dioctyl Terephthalate

It is polyvinyl chloride (PVC) plastic with an excellent performance of the main Plasticizer.Compared with DOP, it has the advantages of heat resistance, cold resistance, low volatility, resistance to extraction, flexibility and electrical insulation.In the products show excellent durability, resistance to soapy water and low temperature flexibility.Because of its low volatility, the use of DOTP can fully meet the temperature requirements of wire and cable, can be widely used in 70 ℃ cable material (International Electrotechnical Commission IEC standards) and other soft PVC products.

Application:

DOTP addition to a large number of cable materials, PVC plasticizer, can also be used for the production of artificial leather film.In addition, has excellent compatibility, can also be used for acrylonitrile derivatives, polyvinyl butyral, nitrile rubber, nitrocellulose and other plasticizers.It can also be used in synthetic rubber plasticizers, paint additives, precision instruments, lubricants, lubricant additives, can also be used as paper softener.

Dioctyl Terephthalate,Dotp Cable Material,Dotp Pvc Plasticizer,Dotp Artificial Leather Membrane

HENAN JINHE INDUSTRY CO.,LTD , https://www.hnironoxide.com