High temperature tank cooling tips:

When the vehicle is running, white steam is suddenly emitted from the engine cover, or the pointer of the water temperature gauge quickly rises to the high temperature mark “H”, indicating that the engine temperature is too high. Usually due to lack of water tank, leaking water or tank fan does not run and other reasons.

The processing method is as follows:

Step one: Immediately find a safe place to stop, but do not turn off immediately. Keep the engine idle and idle and continue to dissipate heat while opening the engine cover to increase the cooling rate.

Note: In case of high water temperature or even pan:

1. Do not try to continue driving so as not to cause a large loss accident.

2. Do not try to open the water tank cover, otherwise it is very likely that hot liquid will be sprayed to cause burns.

3, do not send cold water to the engine block, cylinder head, it is likely to cause the cylinder burst due to rapid cooling.

Step 2: After a period of time, check if there is water leakage under the car.

Step 3: After the water temperature indicator is lowered to the proper temperature position, turn off the engine.

Step 4: Wrap the water tank cover with a wet towel and slowly open the first switch (about 1/4 turn). After the steam pressure is released, fully open the water tank cover to check the water volume and water quality in the water tank, and the fan belt. Is there an exception? If there is not enough water, you should slowly add water near the highest mark.

Note: If the water tank is leaking or the fan belt is loose or broken, you can call the towing company to wait for the trailer to rescue. If necessary, you can also drive the car to the service plant for maintenance at a low speed after the engine is completely cooled. Remember, you can't drive at normal speed, or it may cause permanent damage to the engine.

Construction Hoist Safety Device

Safety is one of the most important for Construction Hoist, thus the Construction Hoist Safety Device is required. SAJ safety device is a product of BQ. When a cage over-speeds the device should act cut off the power stop the cage on mast gradually. The safety device is adjusted and sealed. Do not disassemble it. The using time limit of safety device are signed on it`s nameplate. Safety device must be delivered to the factory and inspected after it reached to time limit.

Safety device board is the connected part between safety device and other structures, it can take the impact of stopping the cage. There are installed lower speed switch, upper travel limit switch and final limit switch, once the switchs touch the relevant cam the cage will act.

We also supply other spare parts for construction hoist, such as construction hoist Mast Section, Construction Hoist Anchorage Frame, Passenger Hoist Cage, Construction Hoist Overload Protector, Sliding Contact Line, Construction Hoist Motor, Construction Hoist Reducer and so on.

SAJ Safety Device,Passenger Hoist Safety Device,Construction Hoist Overload Protector,Overload Limiter,Anti-fall Device

SHEN YANG BAOQUAN BUSINESS CO., LTD , https://www.sysuspendedplatform.com