The general dry filter failure recommendation is to replace the new filter, without a new filter and then carry out a simple activation process, remove the filter, soak in clean gasoline, so that after the dirt is fluffy, then tap the filter At the periphery of the device, dirt will fall off, and then it will be repeatedly cleaned in gasoline and then removed. Then use dry nitrogen to repeatedly blow the two ports of the filter, and then continue to clean it repeatedly in clean gasoline.
The removal of the dry filter needs to be handled by a professional because it requires a specific oven and technology. After removing the filter, place the port under the lamp to observe any dirt. After confirming the cleaning, place it in the oven, raise the temperature to 200 degrees, continue baking for more than 4 hours, and then remove it. Repeat the flush with dry nitrogen from both ends and bake it in the oven for 2 hours. Wait for the oven to cool naturally to room temperature and take it out again. Before removal, the two sides of the filter must be sealed with soft plugs in the chamber so that the filter can be reused.
The Convector heater warm the room as it passes over a heated coil; some use a fan to forced in the cool air to heat. The heated air rises naturally or is forced out by a fan and spreads into the space to warm room.
A convection heater is a type of heater that uses convection currents to heat and circulate air. These currents circulate throughout the body of the appliance and across its heating element.
Convector heater including glass convection heater, Metal Convection Heater, also mini convector heater can be a Frost Heater.
welcome to OEM,thank you
Electric Convector Heater,Wall Mounted Convector Heater ,Dimplex Convector Heater,Convector Heater With Timer
Fenry Manufacturing Co., Ltd , https://www.fenry-fan-heater.com