The magnetic starter consists of a steel stamped enclosure, a steel floor, an AC contactor, a thermal relay, and corresponding wiring. When used, it should be equipped with a start stop button switch, and the manual signal cable should be properly connected. When the start button is pressed, the AC contactor coil installed in the magnetic starter is energized, the armature drives the contact group to close, and the electrical (usually motor) power supply is turned on, and self-locking is performed through the auxiliary contact. When the stop button is pressed, the internal AC contactor coil is de-energized and the contacts are opened, and the power supply is cut off and unlocked.

According to different control needs, the magnetic starter can also be flexibly wired to enable it to perform electric and change equal functions. The built-in thermal relay provides overload protection of the controlled motor. The setting current of the thermal relay should meet the motor power requirement.

The magnetic starter is a full-voltage direct start and is used in both the grid capacity and the load allowing direct start of full pressure. The advantages are easy to operate and control, easy to maintain, and more economical. It is mainly used for starting small-power motors. Motors larger than 11kw are not suitable for this method.

The magnetic starter is composed of AC contactors and thermal relays. A protected magnetic starter with a hermetic enclosure is called an open type magnetic starter without a housing. Magnetic starters are often used to operate controls for locally controlled or remotely controlled motors. The thermal relay in the magnetic starter has the protection characteristic of disconnecting the circuit when it is overloaded. The loss of pressure protection is achieved through the AC contactor (operated by the button), and the magnetic starter does not have the function of short circuit protection. The main circuit is fitted with fuses.

Wafer Butterfly Valve

Summary:

The valve has compacted structure, small flow-resistance with the flow pattern tend to be straight so that no sundries is kept inside. What`s more, it is light and convenient to install. The valve can be applied to cut off or regulate the flow of media. The valve can be actuated by operating lever, handle wheel, electric actuator or pneumatic actuator.

Unique Design:

The disc and the stem are connected without the structure of pin bolts, which guarantees no inner leakage.

Sealed surface of the disc is spherically shaped, which promotes the sealing capacity and increases the durability, which is to say even if opened and closed with pressure more than 50000 times, it remains no leakage.

Upon requests, the disc can be coated with Nylon or F46, Excellent anti-corrosion.

The valve body is coated with epoxy resin without any exposure of iron.

Reliable Sanitation:

The epoxy resin and rubber used comply with sanitary standard DVGW

Appling Area:

The valve can be used in water supply and drainage, disposing of polluted water, heat supply, gas, ship industry, metallurgical industry, energy system and textile and so on, especially applicable to those occasions that bi-directional sealing and valve body are easily eroded.

Wafer Butterfly Valve,Butterfly Valve Wafer Type,Iron Butterfly Valve Wafer Type,Ductile Iron Wafer Butterfly Valve

SUZHOU YUEDA VALVE CO., LTD. , https://www.jsyuedavalve.com